Adding the Back Supports

  1. Cut four back support pieces (D) from 1x4 pine, each 79 inches long.
  2. Attach two back support pieces (D) to the center back of the assembled cupboard, overlapping them as shown in Figure 5. Glue and screw the supports (D) to the backs (A and B) using 1-1/4-inch-long screws placed about every 6 inches.
  3. Attach the remaining two back support pieces (D) to the outer edges of the cupboard backs (A and B), flush with the re-attached trim (C). Glue and screw them to the cupboard backs (A and B) using 1-1/4-inch-long screws spaced approximately 6 inches apart.
0 0

Post a comment