Headboard Back

1 To make the back the correct size to fit into the frame, cut the plywood slightly oversize, place it on the floor and lay the frame over the top of it. Draw around the inside edge on to the plywood with a pencil and then cut out with a panel saw.

2 To fit the back into the frame, spread glue around the rebate, lay in the plywood back and secure it with lin (25mm) panel pins. Because the base of the rebate is not thick enough to hold the pins, you will need to angle them at 45° so that they fix into the sides of the rebate (see Fig 10.3).

0 0

Post a comment