Materials List

ItNIMIH)DIMI SKIONS

PARTS

  1. Rails (9)
  2. Crossmember
  3. Diagonals (total length)
  4. Stiles (2)

Vx1'x72(T Vx1ft'x24'

  • This includes sufficient stock tor waste.
  • This includes sufficient stock tor waste.

HARDWARE

4d Galvanized nails (% lb.) 8d Galvanized nails j% lb.)

EXPLODED VIEW

Cut the parts to size. Choose the wood you B want to use for the mat. Since the parts arc narr<>w and relatively small, you may be able to make the mat from the scraps left over from a fence or deck project. However, no matter what wood you use, make sure that at least one face of the boards is rough-cut. This rough surface makes a better scraper and removes the dirt from your shoes more effectively than wood that has been sur faced smooth on both faces. This is why we recommend that you use cedar — western red cedar is commonly sold with one face rough-cut.

Kip and cut the rails, stiles, and crossmcmber to the sizes shown in the Materials List. Rip the total length of stock you'll need to make the diagonals, but don't cut the diagonals to length just yet.

Assemble the base rails arid cross- them in place, temporarily tack both ends of each rail to i member. Carefully lay out the seven base rails the scrap. Lay the crossmember in place and fasten it to on a large scrap of plywood or particle board. To keep the base rails with 4d nails.

TKy 7/ '15/ If you're making more than one of these mats for a walkway or a patio, you may want to make a plywood template. Instead of tacking the rails to a plywood scrap, nail blocks of wood to the plywood to position the rails and keep them in place while you build each mat. This will not only save you the trouble of tacking and un-tacking the rails; it will ensure that all the mats you make are exactly the same size.

FRONT VIEW

SIDE VIEW

CfilMK DOORMAT

0 0

Post a comment