Materials List

IINHIIIt) IHMINNK >fs>

IINHIIIt) IHMINNK >fs>

A.

Top/back and seat planks (8)

1 ft" x 3ft" x 60"

B.

Top/back supports (2)

1ft"x5ft"x 18"

C.

Back legs (2)

1 ft" x 3ft" x 29"

D.

Front legs (2)

1 ft" x 3ft" x 17"

E.

Back braces (2)

1 ft" x 3ft" X 49"

F.

Seat supports |2) 1 ft" x 3ft" x 24ft"

HARDWARE

x 3ft" Carnage bolts with two washers and two stop nuts each (2 sets)

%" x 3" Carnage bolts with washers and nuts (8 sets) %" x 3" Lag screws and washers (8 sets) %" x 5" Eyebolts with two washers and one wing nut each (2 sets) lOd Decking nails (*/« lb.)

EXPLODED VIEW

Cut all the parta to their proper size.

I Cut the parts to the sizes shown in the Materials List. Miter the ends of the back legs, front legs, and seat supports at 85? as shown in the drawings. Note that both ends of the front legs and the supports are mitered, while one end of the back is cut square and the other mitered. Furthermore, the mitered ends of the front legs must be cut parallel. The ends of the supports are mitered in opposite directions.

Shape the back legs and the back/ top supports. Cut the 1 Vi"-dccp, 3 ^ "long notches in the back legs using a band saw or sabre saw. Also, cut out the shapes of the back/top supports. Drill V pivot holes in the legs and the supports. l>o not, however, drill the lock holes just yet.

-H^l

TOP/BACK SUPPORT LAYOUT

0 0

Post a comment