Rabbeting the back slats

Cut the rabbets at the ends of the back slats on your table saw. Install a dado head and adjust its width to slightly more than Vz inch. Then attach an auxiliary fence, position the fence for a '/-inch cutting width, and raise the blades into the wooden fence to notch it, making sure that the dado head is clear of the metal one. Adjust the cutting height to one-half the slat thickness and screw an extension board to the miter gauge. Feed the slats rounded-over side up, holding the stock flush against the fence and miter gauge extension while you make the cut (above).

Was this article helpful?

0 0
Woodworking Tools and Installation Tips

Woodworking Tools and Installation Tips

There are a lot of things that either needs to be repaired, or put together when youre a homeowner. If youre a new homeowner, and have just gotten out of apartment style living, you might want to take this list with you to the hardware store. From remolding jobs to putting together furniture you can use these 5 power tools to get your stuff together. Dont forget too that youll need a few extra tools for other jobs around the house.

Get My Free Ebook

Post a comment