X

result and loosen the joint. If the front is upright and the side canted then the tails are set out in the usual way, but the shoulders are sawn parallel to the bevel of the long side edge and not at right angles. Whichever piece is canted must be cut full to allow for the bevelling, and the bevel clearly marked or part of the half pin may be lost if the allowance is insufficient. (See also Double bevel dovetail joints, below, and Canted fronts, pp. 249-50.)

Was this article helpful?

0 0
Woodworking Tools and Installation Tips

Woodworking Tools and Installation Tips

There are a lot of things that either needs to be repaired, or put together when youre a homeowner. If youre a new homeowner, and have just gotten out of apartment style living, you might want to take this list with you to the hardware store. From remolding jobs to putting together furniture you can use these 5 power tools to get your stuff together. Dont forget too that youll need a few extra tools for other jobs around the house.

Get My Free Ebook


Post a comment