Next construct the base assembly

IRip 1 !/i6M-thick stock to 25/s"wide for the base front/back (E) and the base

W holes

V2" hole

W holes

V2" hole

vi" dowel 1 3/i" long

END CAP

END CAP

V2" hole W hole

V2" hole W hole

END CAP

3/i" counter-bore Vi" deep on top end cap only

END CAP

ends (F). Miter-cut these parts to the lengths in the Materials List.

2 Rip and miter-cut the four corner cleats (G) from l'/ie"-thick stock to the size listed in the Materials List. Referring to Drawing 10a, drill the 3/s" hole through each of these parts. Then, mark the position of the countersunk holes, where shown, centering them on the edge of each corner cleat.

q clamping the end caps

Match grain direction of each pair of end caps.

B assembly

Match grain direction of each pair of end caps.

Center end caps on column.

1/2u-thick scrapwood spacers

Center end caps on column.

1/2u-thick scrapwood spacers cutting the top caps

3/i" counter-bore Vi" deep on top end cap only

B shelf-drilling jig

W'-square strips

W'-square strips

Vz" hole 3/i"-thick plywood
Shower Head Plumbing Fittings

Note: Do not drill these holes yet. You'll do that after gluing the corner cleats into position.

3 Glue and band-clamp the four base parts (E, F), making sure the assembly is flat and square. Apply glue to one of the corner cleats, and position it in

Woodworking Tools and Installation Tips

Woodworking Tools and Installation Tips

There are a lot of things that either needs to be repaired, or put together when youre a homeowner. If youre a new homeowner, and have just gotten out of apartment style living, you might want to take this list with you to the hardware store. From remolding jobs to putting together furniture you can use these 5 power tools to get your stuff together. Dont forget too that youll need a few extra tools for other jobs around the house.

Get My Free Ebook


Post a comment