Routing Detail

Edge-rounding bit

Center bit along

7/m" pilot holes W deep k of board

Edge-rounding bit

3 Glue and clamp the clock assembly (A, B), checking for square. Remove excess glue with a damp cloth.

4 Cut the exterior top and bottom pieces (C) to size.

Fit your table-mounted router with an edge-rounding bit (we used a Craftsman 26337) and fence. Position the fence and bit, where shown on Drawing 1a. Using the same detail for reference, position the fence and bit,

Router table

5/32" hole, countersunk

(Section view)

x 21/2" brass no-mortise hinge

Mite red corners

Va x 10"/16x 1011/16" glass

x 21/2" brass no-mortise hinge

Mite red corners

Magnetic catch screw (requires a W hole 1/4 " deep)

m glass detail

Magnetic catch screw (requires a W hole 1/4 " deep)

10%" rabbets W deep

  • 19x1/2" brad
  • e" rabbet 1/2" deep, routed after door is assembled
  • 19x1/2" brad

E3 panel detail

%" rabbet 1/2" deep, routed after door is assembled

1/4" groove %"deep

Glass

es tenon detail

tenon

where shown. (We test-cut ¥4" scrap stock first to verify that the routed cut was centered along the edge of the stock.)

6 Rout the front and side edges (not the back edge) of the exterior top and bottom pieces (C). When making the last cut (across the grain), use a piece of scrap stock to reduce splintering, as shown on Drawing 2.

Mark the %x4" notch on the back edge of the top exterior part (C), where shown on Drawing 1. With a bandsaw or scrollsaw, cut the marked notch to shape.

Woodworking Tools and Installation Tips

Woodworking Tools and Installation Tips

There are a lot of things that either needs to be repaired, or put together when youre a homeowner. If youre a new homeowner, and have just gotten out of apartment style living, you might want to take this list with you to the hardware store. From remolding jobs to putting together furniture you can use these 5 power tools to get your stuff together. Dont forget too that youll need a few extra tools for other jobs around the house.

Get My Free Ebook


Responses

  • Edwin Bruce
    How to detail furniture?
    7 years ago

Post a comment