IUse a circle cutter to make the 37/ie," diameter cover plate (G) from W-thick tempered hardboard. Refer to Drawing 5 for the proper position of the fly cutter. Also see Shop Tip No. 1, at right.
2 Now, cut the base insert (H), checking the dimensions against the inside of the lantern assembly. Draw .diagonal marks to quickly locate the center, and then drill a 1 Vs" hole.
3Get a piece of %"-thick stock to make the feet (I). Rip and crosscut four 2V8" squares. Attach to the base (E) with glue and brads, allowing a W projection on both outside edges of the feet. Be certain that the grain in the feet and the base runs in the same direction.
Was this article helpful?