Routing the molding

Cut a board longer and wider than you will need for the three pieces of molding. Install a Roman ogee bit (inset) in your router and mount the tool in a table. Align the bit's pilot bearing with the fence and adjust the cutting height to leave a flat lip no more than % inch thick on the edge of the stock above the molding. Mount two featherboards on the fence and one on the table to secure the workpiece. (In this illustration, the featherboard on the out-feed side of the fence has been removed for clarity.) Turn on the tool and feed the stock (right). To complete the pass, move to the outfeed side of the table and pull the stock through the end of the cut. Make several passes, increasing the width of cut '/a inch at a time. Rip the molding strips from the board on your table saw, then cut them to length, mitering both ends of the front piece and the front end of the side pieces.

Featherboard

Molding stock

Roman ogee

Molding base
How To Sell Furniture

How To Sell Furniture

Types Of Furniture To Sell. There are many types of products you can sell. You just need to determine who your target market is and what specific item they want. Or you could sell a couple different ones in a package deal.

Get My Free Ebook


Post a comment