Making the corner blocks

Attach a triangular corner block to each joint between the end rail and the side rails; this will reinforce the back corners of the table and keep it square. To fit the blocks into the table corners, make a 45° miter cut at each end of the blocks and mark four points on the long edge, two near each end. Next, bore pocket holes through the blocks for the screws that will secure them to the rails. Install a V4-inch Forstner bit in your drill press and clamp a backup panel to the machine table. Secure the block in a handscrew and drill a shallow hole to recess the screw head. Reposition the block to bore the next hole, then turn the block around in the handscrew to drill the holes near the other end. Repeat the process with a smaller brad-point bit to bore clearance holes (left). Finally, with the block top-face down on the table, drill a counter-bored hole through the middle of the surface; this hole will enable you to fasten to the block to the table top.

How To Sell Furniture

How To Sell Furniture

Types Of Furniture To Sell. There are many types of products you can sell. You just need to determine who your target market is and what specific item they want. Or you could sell a couple different ones in a package deal.

Get My Free Ebook


Post a comment