The Base

The base consists of two mitered frames, see Fig. 6. Once again, these eight pieces are cut to rough length, and then the molding cuts are made on the router table.

Next, the four pieces (E) for the base frame are mitered to length. I tried to cut this frame so the measurement between the shoulders of the molded edges wras a total of Vi wider than the assembled case (sides and web frames).

Then the four pieces (D) for the kick board frame are mitered to fit in the rabbets of the base frame, and glue blocks are cut to strengthen the corners.

assembly. Finally, these two frames can be glued and clamped together. Then when it comes time to mount the cabinet to this base, simply screw the base frame to the bottom web frame, see Fig. 7.

Was this article helpful?

0 0

Post a comment