Align Face Of Jig With Shoulder Of Tenon

To miter the corners of the molding, make a simple jig out of a thick piece of scrap. Cut, a groove to hold the rails and stiles, and miter the end at ¿5°.

Place the stile in the jig, lining up I the chisel cut (made in Step 5) with the miteredface of the jig. Then pare off the corner of the molding with a chisel.

m For the rail, line up the shoulder of I X the tenon with the m itered face of the jig. Then caref ully pare down the molding until the corner is also cut at ¿5°.

STILE

Was this article helpful?

0 0

Post a comment